E-mu Emulator Sampler User Forum for the EIII EII EI and EIII XP

General Category => EIII XP General Discussion => Topic started by: arnoldorodeo on June 25, 2017, 11:12:51 AM



Title: OLED display for EMU III XP : I would need some advices
Post by: arnoldorodeo on June 25, 2017, 11:12:51 AM
Hello !
Did anybody already replace old display of EMU III XP (rack) by a brand new OLED display ?
Basically I ordered one on eBay (Newhaven brand) that "should" fit perfectly on my beloved sampler. Any instructions (soldering, pins etc..) about the right way to do it would be welcome !!
Arnold


Title: Re: OLED display for EMU III XP : I would need some advices
Post by: obsoletemachines on June 26, 2017, 05:48:59 AM
hi i used a vishay oled display and installed it last month.

you need to remove screws, then the pins at the header as well as two further connections for anode/cathode and then it lifts away.

i got myself another pin header to solder on to the new OLED board, then on to the EMU EIIIXP Panel board as i knew it would be a cleaner job that way.  I had to snip the pins to shorter lengths. 

I also removed the inverter from the main board.

Let me know if you need any assistance


Title: Re: OLED display for EMU III XP : I would need some advices
Post by: arnoldorodeo on June 26, 2017, 09:12:09 AM
hi i used a vishay oled display and installed it last month.

you need to remove screws, then the pins at the header as well as two further connections for anode/cathode and then it lifts away.

i got myself another pin header to solder on to the new OLED board, then on to the EMU EIIIXP Panel board as i knew it would be a cleaner job that way.  I had to snip the pins to shorter lengths. 

I also removed the inverter from the main board.

Let me know if you need any assistance


Thanks a lot for your help ! that is very helpful. Fact is I ordered another brand of OLED (Newhaven) so I would need to know if this is the same way of proceeding?


Title: Re: OLED display for EMU III XP : I would need some advices
Post by: obsoletemachines on June 28, 2017, 03:11:58 AM
its the same, standard 14pin interface

As long as you have the oled you do not use the A/K



Title: Re: OLED display for EMU III XP : I would need some advices
Post by: arnoldorodeo on June 28, 2017, 04:25:10 AM
Thanks a lot ! I will keep you informed asap  :)