emuser rebuild - Errorcode 1046

(1/1)

slette:
Hi

I have rebuilt the EMUSer. Now I get unfortunately always the error code 1046 displayed (with and without connected Emax!)
I think and hope that my wiring diagram is correct.
The RS422 port on EMAX successfully tested by diagnostics (Passed)
but oscilloscope shows instead of 500kHz only 150HZ between CLK(7) and GND(3) !?

can someone help?

slette:
Also when sending data via MIDI with EMXP I get the 1046 error message. (Midi-IF= Scarlet 2i4)
With the Sysex tool from Elektron (c6) I can successfully send data to the Emax. (Delay times at least 50ms!).

slette:
So, rebuilt from scratch again today and it works! The circuit diagram is correct.
My DSO150 has only a bandwidth of 200kHz, so of course I can not measure the CLK-signal of the Emax!

And sorry for the monologue...

Navigation

[0] Message Index