data slider not working

[vegas]

HI,

Ive tried recalibrating many times but no luck.
Help

[dr.c]

A tip : when you calibrate, BEFORE, put your DATA slider half way down (or up)?
Thne, calibrate.

When you recalibrate, does it show different values ?

[vegas]

Hi,
Thx for the response.
There is no response from the data slider when i calibrate-(does not change values- only in the 'minimal value and maximum value area)
When recalibrating volume for example the volume slider changes the values, not so with the data slider. 
Cheers
T

[dr.c]

As you can see, the slider is connected on one side to the +5V, the other end at the ground, and the slider goes from +5 to 0V.

Check if on the slider, you have 5V, or maybe, the slider is dead !

See enclosed doc, zipped pdf file at :

http://mapage.noos.fr/dr.c/EIII.Pdf.zip

[vegas]

Hi,

Ok so I checked the voltage and it seemed to be working so the slider was not the problem.

I ended up in the master special mode with the magic code 1358
and went into the display/front panel menu and within the data slider section I tried it and finally a response from the slider.  From there, I recalibrated the slider, turned the unit off and on and voila we are good...for now.

Thanks for your help Doc.

[dr.c]

Stoiyo vodka, tovaritch !

Stop vodka, komrad ! (just joking) 

[vegas]

an interesting thing happened....
My data slider was not working for a whle even After numerous recalibrates/magic codes etc...
I checked voltage to slider and it was over 5 volts (5.5 or something like that)
so...I lowered the power supply trim pot to 5 volts did a recalibrate and voila it works again.