|
Title: HxC in EII+HD. Disk 1 or 2? Post by: punkdisco on June 19, 2014, 12:14:20 AM Whilst waiting for my HxC to arrive I have read everything I can find on the HxC install. It is extremely well documented but,I can not find any info on recommended setups in the HD.
I intend to install the HxC where the existing floppy is, above the HD, but: After there any advantages in making the HxC drive 1 or 2? I think I would still want to boot off the HD as I assume it will be faster? In which case the HxC will need to be drive 2? Thanks for any pointers.. Paul London Title: Re: HxC in EII+HD. Disk 1 or 2? Post by: punkdisco on June 20, 2014, 11:40:07 AM Drive arrived today, just in time for the weekend! Unfortunately, Im short of a cable so off to Maplin tomorrow.
Im still planning putting the HxC as drive 2 so I can still do quicker OS loading from the HD. Any views please? thanks, Paul Title: Re: HxC in EII+HD. Disk 1 or 2? Post by: rtech on June 20, 2014, 08:12:35 PM You cant select what drive the HD is set to. I believe that if you have an EII HD the floppy is always set to 1. Remember the HD on the EII is early SCSI so it has a small daughter board that goes where the floppy controller chip goes then the floppy controller chip sits on the daughter board. I know this because I have an EII + HD that I removed the Hard Drive and converted it to just a EII +. The EII+HD has a different Main Firmware/EPROM, so I had to change it. The boot process starts by checking if there is a disk in the floppy drive and tries to boot from it, if there isnt one then it boots from the HD. Or the other way around it, its been a while since I used my EII, since its currently not working (power supply issue).
Title: Re: HxC in EII+HD. Disk 1 or 2? Post by: punkdisco on June 23, 2014, 04:28:00 AM Hey rtech
Thanks for the reply. Yeah, I see what you mean. There was no decissions required. Just simply attached a 3.5” connector to the existing floppy ribbon cable and it all worked fine (after quite a few hours of investigation on the HxC front..). Thanks again for the reply.. Paul London www.punkdisco.co.uk Title: Re: HxC in EII+HD. Disk 1 or 2? Post by: EII4ever on December 28, 2015, 02:24:57 PM Hi,
I know this is an older post but I'm about to decide what to do with the EII+HD I have. Would you recommend HxC? If so version F (black one). Would I need other bits & pieces to go with it? About the question disk 1 or 2 are there any updates? Thanks in advance |