EIII with ZuluScsi

[Michaelmeinl]

Hello everyone,

I am new to the Forum and first of all thank you everybody for contributing.

I have an issue getting a ZuluScsi Drive to work in my EIII

My internal Harddisk died and I just wanted to replace it with the ZuluDrive.

However I can?t seem to get it to work.

First I tried it with the internalHD unplugged and the Zulu termination DIP "ON". The EIII does not even show any display and won?t start.
Then I got an active Scsi Terminator (Ribbon Cable). The EIII will start but the Zulu is not responding (no LED blinking).

When I have the old InternalHD plugged in after the Zulu the EIII will boot from the Floppy and I can access the ZuluDrive. But once I press any button the Display reads "no such bank".

Did anybody sucessfully install a ZuluScsi in the EIII and maybe point me in the right direction ?

Thanks in advance
Michael 

[Deft]

Hi, I don`t have Zulu, but i believe it is pretty the same as SCSI2SD. So what needed to be done - you need to configure zulu to 1gb partition size (EIII wont work with more than 1gb), and then try to turn on-off SCSI termination (usual scsi hell), SCSI ID (I use 1) and try switching SCSI 2 mode on off.

My personal scsi setup:   

ID 1 - E3 SCSI2SD HDD
ID 2 - Power MAC G3 HDD (also SCSI2SD)
ID 3 - E3
ID 5 - SCSI CD in Power MAC G3
ID 7 - CPU Power MAC G3

Power MAC is used for Alchemy, Sound Designer, Turbosynth, EIII remote.

All the best,
Kirill

[Michaelmeinl]

Great, thank you for the Tips !!

The following seems to be working:

I downloaded a bootable HD Image from EMXP.com.

Now the EIII boots from the Zuludrive. I just have to figure out how to get it to work without the internal HD Plugged in.

Thanks for the info with the 1 GB Partitions !! That helped a lot !

Cheers

[Deft]

U r welcome ) Just unplug the HDD and try switching SCSI termination on-off on zulu.